green wrap car Wrapping the Tesla's hood with vinyl film is not difficult.

green wrap car

It can be done with ease if you have the right approach. Here's how it can be done: Careful prepping Make sure you thoroughly clean your vehicle before applying the material. It is better to clean the entire section once more. green wrap car Then, use a microfiber towel to wipe the hood clean with a surface cleaner. Next, lightly wipe the hood with a tackcloth. Application Once the prep work is complete, green wrap car you can begin applying the material. Two people can make the process much quicker. Make sure you have enough material on each side of your vehicle wrap.

Do not let the backing paper touch the surface. If you are working in a team, make sure that everyone pulls at the backing paper simultaneously. This will prevent wrinkles and help to keep the liner from getting too wrinkled. Start at the top corners After releasing the liner from the car wrap, flatten it before letting the wrap touch the hood. Next, green wrap car attach it to the upper corners and then pull away. As you pull, you can create glass from the top corners. These sharp corners will help reduce wrinkle risk. Don't squeegee the middle until this point. Otherwise, you might get adhesive lines. green wrap car After removing the film, you are able to use your squeegee starting at the center. www.vinylcarwrapshop.com You can then proceed to cover the hood using overlapping strokes of your squeegee from top-to-bottom. green wrap car Your squeegee should be held at a low angle so that it is as close as possible to the surface. This will help to avoid adhesive lines. Before adding heat, double-check Double-check that the vehicle wrap has been properly applied after it's done. You should continue working from the upper corners and wrap the film around the hood's top edge. You will feel tension at the outer edge of the car wrap, even though you didn't stretch it very much. green wrap car This is where you should take advantage of it. Heat the corner and vinyl will shrink under the hood. This can give you great durability. Get rid of the excess Remove any excess material from the hood. Angle your blade away from edge. This will allow you to have enough material for wrapping later. green wrap car Seal the edge after you are done cutting. It's that simple. You should now have a quality Tesla hood that looks like paint and is long-lasting. green wrap car Find out more about wrapping at www.teckwrap.com